ChamberTite Draw Pit Chambers

Forecourt Solutions are pleased to announce the addition of Draw Pits and Access Chambers to the ever growing ChamberTite range of products. The ChamberTite range of DrawPits is available in a range of sizes to suit most applications and to make even to most difficult projects easy we can offer a custom design service to suit any application. Each chamber is a combination of polyethylene chamber interfaced to a suitably sized cover from the CompositeCovers range. Requirements for large chambers can be met by utalising modular manhole covers with free access being achieved by the use of removable support beams. Chambers can be divided in sections to allow single chambers to be used for most than one cabling solution.

Common chamber sizes of 450 and 600 mm will be usually be held in stock to meet urgent requirements however special sizes and larger quantities will be manufactured to order.

New 1150 x 1150 mm Draw Pit now available with adjustable burial depths. Installs below our own 900 mm circular watertight manhole cover CC0900D400 Pas 26. See below for further details


   Three_Draw_Pits 

 

Features and Benefits

Cost effective off the shelf solutions

High quality polyethylene chamber rectangular or circular

Complete boxes or open based options

Watertight options

Chambers can be divided into sections if required

Range of conduit and duct seals to suit most applications

Composite manhole covers with security options if required

Range of load ratings available from A15 to D400

Colours to suit customer requirements

Suitable for direct burial without the need for concrete shuttering

Quick to install, simple to cut for conduit and duct entries

Non slip covers can be customised to customer requirements

Download our Drawpit Datasheet here:  ChamberTite_Electrical_Draw_Pit.pdf      


Drawpit_Datasheet_1 Drawpit_Datasheet_2 


Forecourts new 1150 x 1150 mm Draw Pit chamber CTS1150-1150 provides a simple quick and watertight solution to your requirements for a greater than 1m x 1m drawpit chamber. Shipped in three sections to ease installation before simple assembly and backfill to your desired burial depth. Manufactured out of high grade polyethylene which will not corrode or deteriorate in the wet alkaline or acid situations. A range of two base heights and three site adjustable riser heights provide flexibility to meet your installation requirements.

For further information please download our new datasheet here CTS1150-1150-600_ChamberTite_DrawPit_Datasheet.pdf

For a dimensional drawing of the DrawPit Chamber download here CTS1150-1150-1_Assembly_Explosion.pdfCTS1150-1150-600_ChamberTite_DrawPit_Datasheet

Large_Draw_Pit_Assembly

























The unit can be either installed beneath our own 900 mm clear opening lightweight high strength composite cover CC0900D400 or traditional cast iron manhole covers.

We can also provide a wide range of flexible entry boots to facilitate the watertight entry of ducts into the Draw Pit chamber.

For further information please download the product datasheet and installation instructions available below or see the full range on the Entry Boots section of our website.

 
   
 

  Site Map